Posted by: Gary from adsl-64-255-97.mia.bellsouth.net on January 11, 2011 at 14:12:53
In Reply to: FMC 2500 Balancer problem posted by Hugh on January 10, 2011 at 19:47:25
Subject: Re: FMC 2500 Balancer problem
There are two F entries that are important.
F11 with the cal puck on (screwed into the right side of faceplate)spin and you should read about .50 in each display.
If you are not getting steady numbers while it is spinning in F11 you either have a sensor or a pc board problem
F50 start will not spin but you can turn manually and should see 0 or 255 with cal puck at 6 oclock.
- Re: FMC 2500 Balancer problem Hugh 1/11/2011
(1)
- Re: FMC 2500 Balancer problem Brad 2/15/2011
(0)
- Re: FMC 2500 Balancer problem Brad 2/15/2011
(0)