Posted by: Hugh from milv-rb-1-206-78.nblk1.cyg.net on January 11, 2011 at 21:14:05
In Reply to: Re: FMC 2500 Balancer problem posted by Gary on January 11, 2011 at 14:12:53
Subject: Re: FMC 2500 Balancer problem
Thanks for the reply
F50 do's read 0 and 255 at 6 o'clock and increments as I turn the shaft.
F11 seams to be a problem. Readings are constant at 1.3 and 1.66 with slug attached. I read that I should be able to adjust them with the two pots on the lower right of the board, but there is no response to adjusting the pots. Tried adjusting with shaft spinning and tried adjusting a couple of turns then recalibrated then F11, same reading 1.3 1.66.
Any ideas?
- Re: FMC 2500 Balancer problem Brad 2/15/2011
(0)