Posted by: Peter from cpe0013d47811f4-cm001bd7a8c658.cpe.net.cable.rogers.com on September 20, 2008 at 18:54:01
Subject: FMC 4100 Wheal Balancer Problem
Hello everyone, I have a John Bean 4100 aka FMC 4100 wheal balancer in the shop and when I close the lid it will just keep spinning, will not stop unless I open the lid. It will not show balance values either. Any ideas which components I should be looking closer at? Don’t see any burnt components on the circuit board the first time I looked over it and fuses are good, thanks.
- Re: FMC 4100 Wheal Balancer Problem matt 10/31/2008
(0)